Filter
Top Products
Part No. 1106628 27 Solara jr.
USING/INSTALLING/ADJUSTING CANTILEVER ARMS
NOTE: The cantilever arms are designed for use with the fixed height back canes only.
USING (FIGURE 3)
1. Pull the actuator of the locking mechanism towards the front of the wheelchair.
2. While holding the actuator of the locking mechanism, pull up on the cantilever arm.
NOTE: If necessary, the locking mechanism in the cantilever arm can be repositioned so the cantilever
arm will open down instead of up. For this adjustment, contact a qualified technician.
3. To lock the cantilever arm, push down until there is an audible click.
4. Pull up on the cantilever arm to make sure it is locked in place.
INSTALLING/ADJUSTING
Installing Cantilever Arm (FIGURE 3).
NOTE: When removing the locknuts and washers from the cantilever arm assembly, leave the top hex
bolt, coved washers and spacer (between adjustment plate and cantilever arm) in place.
1. Slide the partially assembled cantilever arm assembly w/mounting hardware through the
back cane. Make sure the adjustment plate is towards the inside of the wheelchair.
NOTE: This includes top hex bolt, coved washers and spacer (between adjustment plate and cantilever arm).
2. Slide the bottom hex bolt (w/coved washer) through the adjustment plate and back cane.
3. Securely tighten the cantilever arm to the wheelchair with two (2) locknuts and washers.
4. Adjust the angle of the cantilever arm, if necessary. Refer to
ADJUSTING CANTILEVER
ARM ANGLE in this section of the manual.
Adjusting Cantilever Arm Height (FIGURE 3).
NOTE: When removing the locknuts and washers from the cantilever arm assembly, leave the top hex
bolt, coved washers and spacer (between adjustment plate and cantilever arm) in place.
1. Remove the two (2) locknuts and washers securing the cantilever arm assembly to the back cane.
2. Remove the cantilever arm assembly with hardware from the back cane.
3. Perform STEPS 1-4 in
INSTALLING CANTILEVER ARM to reposition the arm at the
desired height.
ARMS/POSITIONING STRAPS
ARMS/POSITIONING STRAPS PROCEDURE 5