Filter
Top Products
Solara jr. 22 Part No. 1106628
PROCEDURE 4 FRONT RIGGINGS
FRONT FRIGGINGS
ADJUSTING ADJUSTABLE ANGLE FLIP-UP FOOTPLATES
(FIGURE 4)
WARNING
When determining the angle of the footplates, make sure the rear of the
footplates does not interfere with the movement of the front casters.
DEPTH ADJUSTMENT
NOTE: Observe the angle of the footplate for reinstallation.
1. Remove the two (2) flat screws, washers and locknuts that secure footplate to the
footplate hinge.
2. Move the footplate to one (1) of four (4) mounting positions.
NOTE: If desired depth is still not obtained, rotate the half clamp on the footplate hinge 180
°
.
3. Retighten the two (2) flat screws, washers and locknuts.
NOTE: The settings for positioning the footplates on the half-clamps may vary for each footplate.
ANGLE ADJUSTMENT
1. Loosen, but do not remove the two (2) flat screws and locknuts that secure the footplate
to the footplate hinge as shown in FIGURE 4.
2. Position the footplate to the necessary angle to accommodate the user (DETAIL "A").
3. Retighten the two (2) flat screws and locknuts.
PERPENDICULAR AND/OR INVERSION/EVERSION ADJUSTMENT
NOTE: It is not necessary to remove the footplate to perform this adjustment.
1. Insert a flathead screwdriver through the half clamp on the footplate.
2. Slowly turn the nylon adjustment screw in or out until the footplate is perpendicular to the
footrest assembly or the desired inversion or eversion is obtained (DETAIL "B").
Footplate Hinge
Nylon
Adjustment
Screw
Footplate Hinge
Half
Clamp
Footplate
Flat Screws
Half Clamp
Locknuts
Washers
FIGURE 4 - ADJUSTING ADJUSTABLE ANGLE FLIP-UP FOOTPLATES
90° Footrest Support
SIDE VIEW OF
FOOTPLATE
AND
FOOTREST
SUPPORT
Footrest Support
Footplate
DETAIL "A" - ANGLE
ADJUSTMENT
DETAIL "B" - PERPENDICULAR
AND/OR INVERSION/EVERSION
ADJUSTMENT
Footplate
Footrest
Support
FRONT VIEW OF
FOOTPLATE AND
FOOTREST SUPPORT.
Nylon
Adjustment
Screw