Filter
Top Products
Solara jr. 56 Part No. 1106628
CONTRACTURE FOOTPLATE HEIGHT ADJUSTMENT
(FIGURE 5)
NOTE: Refer to the WARNINGS in PROCEDURE 1
of this manual.
1. Remove the mounting screw, two (2)
coved washers, washer and locknut that
secure the footplate bracket to the
contracture support.
2. Move the footplate bracket UP/DOWN
to achieve desired height.
3. Align the mounting hole in the footplate
bracket with one (1) of seven (7) mount-
ing holes on the contracture support.
4. Secure the footplate bracket to the
contracture support with the mounting
screw, two (2) coved washers, washer and
locknut. Securely tighten.
5. If necessary repeat STEPS 1-4 on remaining contracture footplate.
REPLACING THE CONTRACTURE FOOTPLATE HEEL LOOP
(FIGURE 6)
NOTE: Refer to the WARNINGS in PROCEDURE 1
of this manual.
1. Tilt the contracture footplate forward to
gain access to the mounting screws that
secure the heel loop to the underside of
the contracture footplate. Refer to
ANGLE ADJUSTMENT OF THE CON-
TRACTURE FOOTPLATE in this proce-
dure of the manual.
2. Remove the four (4) mounting screws and
washers that secure the EXISTING heel loop to the contracture footplate.
3. Reverse STEPS 1-2 to install the NEW heel loop.
FIGURE 5 - CONTRACTURE
FOOTPLATE HEIGHT
ADJUSTMENT
Mounting Screws
Lock Nut
Washers
Footplate
Bracket
Contracture Support
Coved
Washers
Mounting
Holes
FIGURE 4 - CONTRACTURE FOOTPLATE DEPTH ADJUSTMENT
Contracture
Footplate
Flat Screws
Washers
Footplate Hinge
Lock Nuts
Mounting Hole
FIGURE 6 - REPLACING THE
CONTRACTURE FOOTPLATE
HEEL LOOP
Contracture Footplate
Washers
Heel Loop
Mounting Screws
Washers
PROCEDURE 10 CONTRACTURE FOOTPLATE
CONTRACTURE FOOTPLATE