Filter
Top Products
Solara jr. 52 Part No. 1106628
PROCEDURE 9 TILT/RECLINE
TILT/RECLINE
ADJUSTING LOWER TILT LOCKING COLLAR (FIGURE 5)
NOTE: This procedure limits the amount of tilt the
wheelchair may have. The maximum amount of tilt
available is 45°. If adjusting the angle the wheelchair
returns to, refer to ADJUSTING UPPER TILT LOCK-
ING COLLAR in this procedure of the manual.
1. Loosen the two (2) socket screws that
secure the tilt locking collar to the tilt slide.
2. Repeat STEP 1 for opposite side of
wheelchair.
NOTE: To determine tilt angle relative to the seat frame,
place a magnetic protractor (available at any hard-
ware store) on the back and adjust the back until the
magnetic protractor reads desired angle of tilt.
3. Tilt the wheelchair to the desired angle of tilt.
4. Position the two (2) tilt locking collars against the bearing housing.
NOTE: Before tightening, ensure that the two (2) tilt locking collars are at the same position on the tilt slide.
5. Securely tighten the four (4) socket screws of the tilt locking collars.
REPLACING BACK OR HEADREST UPHOLSTERY
(RECLINER MODELS ONLY) (FIGURE 6)
REPLACING THE BACK UPHOLSTERY
1. Remove the ten (10) phillips screws
(depending on back height) that secure
the back upholstery to the back canes.
2. Remove existing back upholstery from
back canes.
3. Install new back upholstery onto the back
canes.
4. Install the ten (10) phillips screws (de-
pending on back height) that secure the
back upholstery to the recliner back
canes.
REPLACING THE HEADREST
UPHOLSTERY
1. Remove the six (6) phillips screws that
secure the headrest upholstery to the headrest extensions.
2. Remove the existing headrest upholstery from the headrest extensions.
3. Install the new headrest upholstery onto the headrest extensions.
4. Install the six (6) phillips screws that secure the headrest upholstery to the headrest
extensions.
Phillips
Screws
Back
Cane
Headrest
Extension
Back
Upholstery
FIGURE 6 - REPLACING BACK OR
HEADREST UPHOLSTERY
(RECLINER MODELS ONLY)
Headrest Upholstery
Socket
Screws
Tilt Slide
Bearing Housing
FIGURE 5 - ADJUSTING LOWER
TILT LOCKING COLLAR
Lower Tilt
Locking Collar