Filter
Top Products
Part No. 1106628 35 Solara jr.
REMOVING
1. Push in the button of the quick release pins.
2. Pull out the quick release pins that secures the stroller handle to the back canes.
3. Remove the stroller handle from the wheelchair and discard.
4. Install the NEW stroller handle. Refer to
INSTALLING STROLLER HANDLES in this
procedure of the manual.
FIGURE 3 - INSTALLING/REMOVING THE ADJUSTABLE ANGLE
STROLLER HANDLES
Stroller Handle
NOTE: Plug buttons not shown for clarity.
INSTALLING/REMOVING/ADJUSTING THE ADJUSTABLE
ANGLE STROLLER HANDLES
NOTE: Adjustable angle stroller handles are bolted onto recliners ONLY.
INSTALLING (FIGURE 3)
1. Remove plug buttons from both back canes.
2. Slide the adjustable height stroller handle into the back canes.
3. Align the mounting holes of the adjustable angle stroller handle and the back cane.
4. Secure adjustable angle stroller handle to the back canes with the two (2) quick-release
pins or the two (2) bolts and locknuts.
5. If necessary, adjust the height. Refer to
ADJUSTING in this procedure of the manual.
REMOVING (FIGURE 3)
1. Press and hold the buttons on the quick-release pins
2. Remove the adjustable angle stroller handle from the back cane.
3. Install plug buttons.
BACK/SEAT PROCEDURE 6
BACK/SEAT
Quick-Release Pin
(or bolt and locknut -
Recliners ONLY)
DETAIL "A" -
QUICK-RELEASE
PIN INSTALLED
Quick-Release Pin
(or bolt and locknut
- Recliners ONLY)
Detent
Ball
Back Cane
NOTE: Bolts and locknuts not shown. Bolts and
locknuts install in same location as quick-release
pins.
Back Cane