Filter
Top Products
Part No. 1106628 51 Solara jr.
POSITIONING TILT LOCKING COLLARS
WARNING
Anterior (forward) tilt is a feature of this wheelchair designed for the USE OF A
HEALTHCARE PROFESSIONAL or ASSISTANT ONLY. Engagement of the anterior
(forward) tilt must NEVER be performed by the wheelchair user. When anterior (for-
ward) tilt is needed, it must ALWAYS be engaged by a HEALTHCARE PROFESSIONAL
or ASSISTANT.
The back height, seat depth, back angle, seating system, tilt angle, seat height, size/
position of the rear wheels, size/position of the front casters, as well as the user condi-
tion directly relate to the stability of the wheelchair. Any change to one (1) or any
combination of the eleven (11) may cause the wheelchair to decrease in stability. These
adjustments MUST be performed by a qualified technician.
DO NOT operate the wheelchair when the seat frame is in the anterior (forward) tilt
position (frame stops in the lower position and approximately 5
°
forward tilt). Serious
bodily injury may occur to the patient and the assistant(s).
TO HEALTHCARE PROFESSIONALS/ASSISTANTS:
Make sure the occupant of the wheelchair is properly positioned in the wheel-
chair BEFORE reclining or inclining (reverse recline) to maintain maximum
stability and safety. Ensure all hands and legs are out of the way of pinch points.
Always engage both wheel locks.
After ANY adjustments, repair or service and BEFORE use, make sure all attach-
ing hardware is tightened securely and locking collars are positioned at the same
position on the tilt slide.
ADJUSTING UPPER TILT LOCKING COLLAR (FIGURE 4)
NOTE: This procedure adjusts the degree of tilt that the wheelchair returns to for normal operation. If the
amount of tilt MUST be limited, refer to ADJUST-
ING LOWER TILT LOCKING COLLAR in this proce-
dure of the manual.
1. Loosen the two (2) socket screws that
secure the tilt locking collar to the tilt slide.
2. Repeat STEP 1 for opposite side of
wheelchair.
NOTE: To determine tilt angle relative to the seat frame,
place a magnetic protractor (available at any hard-
ware store) on the back and adjust the back until the
magnetic protractor reads desired angle of tilt.
3. Tilt the wheelchair to the desired angle of tilt.
4. Position the two (2) tilt locking collars against the bearing housing.
NOTE: Before tightening, ensure that the two (2) tilt locking collars are at the same position on the tilt slide.
5. Securely tighten the four (4) socket screws of the tilt locking collars.
Socket Screw
Upper Tilt
Locking
Collar
Tilt Slide
Bearing Housing
FIGURE 4 - ADJUSTING UPPER
TILT LOCKING COLLAR
TILT/RECLINE PROCEDURE 9
TILT/RECLINE