Filter
Top Products
Part No. 1106628 25 Solara jr.
WARNING
Never try to lift or tip the wheelchair by the arms, serious injury can occur.
After ANY adjustments, repair or service and BEFORE use, make sure all attach-
ing hardware is tightened securely - otherwise injury or damage may occur.
This Procedure Includes the Following:
Using/Adjusting Dual Point Arms
Replacing Dual Point Arm Pad
Replacing Dual Point Arm Clothing Guards
Using/Installing/Adjusting Cantilever Arms
Arm Pad Replacement for Cantilever Arms
Installing/Removing T-Arms
Adjusting the T-Arms
Adjusting T-Arm Transfer Assists and/or Side Guards
Installing/Replacing Seat Positioning Straps
Installing/Replacing Chest Positioning Straps
PROCEDURE 5ARMS/POSITIONING STRAPS
USING/ADJUSTING DUAL POINT ARMS (FIGURE 1)
WARNING
Make sure the locking mechanism is secured before using the wheelchair.
ADJUSTING ARMREST HEIGHT
1. Unlock the armrest by flipping the height release lever on the top front of the armrest to
the UP (HORIZONTAL) position.
2. Adjust armrest to desired height.
NOTE: Armrest locks MUST be in the unlocked position when placing armrest into the arm assembly.
3. Lock the armrest by pressing the release lever into the DOWN (VERTICAL) position
when the desired armrest height is achieved.
REMOVING ARMRESTS
1. Unlock the arm assembly by flipping the armrest release lever located on the side rail to
the UP (HORIZONTAL) position.
2. Remove armrest from the wheelchair.
REPLACING ARMRESTS
NOTE: Armrest release levers MUST be in the unlocked position when placing armrests into the arm
sockets.
1. Lock the armrest by pressing the armrest release lever into the DOWN (VERTICAL)
position.
ARMS/POSITIONING STRAPS