Filter
Top Products
Solara jr. 46 Part No. 1106628
Release
Button
Wheelchair Frame
FIGURE 5 - INSTALLING/ADJUSTING ANTI-TIPPERS
Anti-tipper
INSTALLING/ADJUSTING ANTI-TIPPERS (FIGURE 5)
NOTE: A 1-1/2 to 2-inch clearance between the bottom of the anti-tipper wheels and the floor MUST be
maintained at all times.
NOTE: If any adjustments/replacement of the rear wheels have been made, the anti-tippers must be adjusted to
maintain the 1-1/2 to 2-inch clearance. If this adjustment cannot be made with the anti-tippers currently in-
stalled, a different model may be required. Consult a qualified technician for assistance.
INSTALLING
1. Remove the anti-tippers from the accessory carton.
WARNING
Anti-tippers MUST be fully engaged and spring buttons fully protruding out of
adjustment holes.
2. Press the release buttons IN and install the anti-tippers with the wheels facing DOWN until
the locking buttons lock in place as shown in FIGURE 5.
NOTE: ALL anti-tippers will install with the wheels facing DOWN.
3. Adjust the anti-tippers. Refer to
ADJUSTING ANTI-TIPPERS in this procedure of the manual.
ADJUSTING
1. Depress the release button on the wheeled portion of the anti-tipper and slide it up/down to
achieve 1-1/2 to 2-inch clearance.
WARNING
Anti-tippers MUST be fully engaged and release buttons fully protruding out of
same respective adjustment holes BEFORE use. This will avoid a 3-Wheeling
situation.
2. Ensure that the release buttons are fully engaged in the adjustment holes and 1-1/2 to 2-
inch clearance is maintained.
A
N
T
I
T
I
P
P
E
R
S
1-1/2 to 2-inch
Clearance
Ground/Floor
WHEEL LOCKS/ANTI-TIPPERSPROCEDURE 8
WHEEL LOCKS/ANTI-TIPPERS