Filter
Top Products
Part No. 1106628 49 Solara jr.
RECLINER OPERATION (FIGURE 2)
WARNING
ALWAYS make sure that the wheel-
chair is stable in the full reclined (back at
180°) position and the full upright (back
at 90°) position BEFORE using the
recliner option.
Before using the recliner option, make
sure the anti-tipper wheel assemblies
are in the lowest adjustment hole (ad-
justment hole closest to the ground/
floor.)
Before using ANY recline position of this wheelchair, make sure the rear wheels are
in the MOST REARWARD position to maintain the stability of the wheelchair. DO
NOT change the handling/maneuverability of the wheelchair by moving the rear
wheels to any of the forward positions. moving the rear wheels to any of the for-
ward positions will change the center of gravity of the wheelchair, making the
wheelchair less stable.
RECLINER OPTION ONLY - ALWAYS return the back to the upright position
before lifting the wheelchair.
Make sure occupant's hands and body are clear of all pinch points BEFORE reclining
back. Pinch Points exist between spreader bar and gas cylinders. Use caution, other-
wise injury may occur.
1. Make sure the wheelchair is on a level surface.
2. Engage the wheel locks. Refer to
USING
THE WHEEL LOCKS in PROCEDURE 8 of
this manual.
3. Inform the occupant of the wheelchair that
the wheelchair is about to be reclined.
4. Make sure occupant's hands and body are
clear of all pinch points.
5. Stand behind the wheelchair and grasp the
stroller handle firmly.
6. Pull up on the handles of the recliner cable
assemblies to activate the gas cylinders.
7. SLOWLY, squeeze the handles of the
recliner cable assemblies and perform one
(1) of the following:
A. RECLINING - allow the back to recline to the desired angle.
B. RETURNING TO UPRIGHT POSITION - Pull up and push the stroller handle towards
the front of the wheelchair until the back is in the upright position.
8. When the back reaches desired angle, slowly release the handles of the recliner cable assemblies.
9. Disengage the wheel locks. Refer to
USING THE WHEEL LOCKS in PROCEDURE 8 of this manual.
FIGURE 2 - RECLINER OPERATION
Stroller
Handle
Handle
Gas
Cylinder
TILT/RECLINE PROCEDURE 9
TILT/RECLINE