Filter
Top Products
Part No. 1106628 23 Solara jr.
COMPOSITE/ARTICULATING FOOTPLATE HEEL LOOP
REPLACEMENT (FIGURE 5)
DISASSEMBLY
Composite.
1. Remove the hex screw and coved spacer
that secure the lower footrest assembly
to the swing away footrest assembly.
2. Remove the lower footrest assembly.
3. Remove the phillips screw and locknut
that secure the heel loop to the footrest.
4. Slide heel loop off of the footrest.
Articulating.
1. Remove the phillips screws, washers and
spacers that secure the heel loop to the
articulating footplate.
REASSEMBLY
1. Replace heel loop.
2. Reverse the disassembly procedures.
NOTE: When securing the heel loop to the footrest as-
sembly, tighten phillips screw until the spacer is secure.
FIGURE 6 - INSTALLING/
REMOVING ELEVATING LEGREST/
CALFPAD ASSEMBLY
Legrest Mounting Pin
Footplate Assembly
Bolt and
Nut
Calfpad
Assembly
Release
Handle
Legrest
Mounting
Tube
Wheelchair
Frame
Lower Footrest
Assembly
Locknut
Heel
Loop
ARTICULATING
FOOTPLATE
Spacer
Spacer
Phillips Screw
Heel
Loop
FIGURE 5 - COMPOSITE/
ARTICULATING FOOTPLATE
HEEL LOOP REPLACEMENT
Phillips
Screws
COMPOSITE FOOTPLATE
Hex Screw and Coved Spacer
Swingaway Footrest Assembly
Washer
INSTALLING/REMOVING ELEVATING LEGREST/CALFPAD
ASSEMBLY (FIGURE 6)
INSTALLING
1. Insert the footplate assembly into the calfpad
assembly and secure it with bolt and nut.
2. Place legrest/calfpad assembly on the
outside of the wheelchair and insert
legrest mounting pin into the legrest
mounting tube on the wheelchair frame.
3. Rotate legrest/calfpad assembly toward the
inside of the wheelchair until it locks in place.
NOTE: The calfpad of the legrest will be on the
inside of the wheelchair when locked in place.
4. Repeat STEPS 1-3 for the other legrest
assembly.
5. Adjust the footplate to the correct height
by loosening the bolt and nut and sliding
the inner tube up or down until desired height is achieved. Securely tighten bolt and nut.
REMOVING
1. Push the legrest release handle inward while rotating the footrest outward.
2. Lift the legrest assembly out of the legrest mounting tube.
PROCEDURE 4FRONT RIGGINGS
FRONT RIGGINGS