Filter
Top Products
Cancelling a MultiWave Bolus
– during programming (a bolus amount or the bolus duration blinks):
There are three ways to cancel a MultiWave Bolus during programming:
• Do not press any key for 20 seconds. The pump returns to the
RUN
screen (timeout).
• Exit to the MULTIWAVE BOLUS screen by pressing
d+a simultaneously.
• Set the total bolus amount to 0.0 units and press
f.
No bolus is delivered.
– during the start delay ( blinks):
• Press s or a. The pump beeps and vibrates.
The pump returns to the
RUN screen.
An alert A8: BOLUS CANCELLED occurs. Press
f twice to confirm
and turn off the alert.
No bolus is delivered.
See the section “Alert A8: BOLUS CANCELLED” (page 153) for more
information
– during bolus delivery:
• You can cancel the immediate delivery by pressing and holding s or
a for 3 seconds until you hear a melody. This cancels the whole
bolus (immediate and Extended Bolus delivery). An alert A8: BOLUS
CANCELLED occurs.
Note:
Once the immediate bolus is delivered, the remaining time, bolus amount,
and the current hourly basal rate are displayed on the RUN screen.
If a Temporary Basal Rate is active at the same time, the remaining time
and amount of the bolus and the amount of the increased or decreased
hourly basal rate are displayed on the RUN screen.
Chapter 4: Boluses and TBRs ACCU-CHEK Spirit Insulin Pump
91