Filter
Top Products
▲
!
If you discover incomplete characters, numbers, or symbols
on the display, put your insulin pump into STOP mode and
perform a system check again by simply removing the battery
for a few seconds. When you reinsert the battery the system
check will occur. If the incomplete characters, numbers, or
symbols remain, your insulin pump may need to be returned
since you may not receive the correct information for
operating your pump. Put your insulin pump into STOP mode
and contact Pump Support at 1-800-688-4578 immediately.
Note:
If the voltage of the battery is too low, the start-up procedure
cannot finish.
Your pump beeps five tones and keeps restarting the start-up
procedure until you remove the battery or until the battery is dead.
Chapter 2: Getting Started ACCU-CHEK Spirit Insulin Pump
31
CAUTION