299Chapter 6. UTILITY MODE
6
6. Fingered chord zone
6. Fingered chord zone
• The chord detection function of the QY700’s Auto-Accom-
paniment is referred to as Fingered Chord, and the range in
which chord detection is performed is called the Fingered
Chord Zone.
• Here you can make on/off settings for Fingered Chord, and
specify the Fingered Chord Zone etc.
1. Press u.
▼ The indicator located above u will light, and you
will enter Utility mode.
2. Press 6 (FngZone) to access the Fingered Chord
Zone page.
3. Move the cursor to the parameter that you wish to set.
4. Use n/y, the data dial, or numeric keypad → e
to set the value.
1. Fingered chord
• Specify whether or not Fingered Chord will be active.
• This setting is linked with the “Fingered Chord” settings
displayed in Song mode Song Play and in Pattern mode
Patch.
0101
1101
OFF (Off), FINGRD (On)
2. Zone low/high
• The Fingered Chord Zone is specified by the lowest (Low)
and highest (High) note.
• Fingered Chord will operate in the keyboard area between
the Low and High Zone settings.
• Notes below the Zone Low are used to specify On Bass or
Original Bass.
• Zone settings can be made using n/y or the data dial,
and also using the microkeyboard of the QY700.
0101
1101
Zone Low C-2 – G8
Zone High C-2 – G8
(Zone Low
<
=
Zone High)
• When Fingered Chord is selected (FINGRD), the keyboard
below Zone High will be dedicated to the Fingered Chord
function, and cannot be played normally.
• These settings are not affected by the Keyboard Transpose
setting.
• For details on Fingered Chord, refer to “Chapter 1. BASIC
CONCEPTS”. (→ p.42)
F1 F2 F3 F4 F5 F6
1System
2MIDI
3MIDI filter
4Sequencer
5Click
6Fingered chord zone
u
