Filter
Top Products
Installation
WFM 601A, WFM 601E & WFM 601M User Manual
1–11
c. Pack dunnage or urethane foam between the instrument and the carton. If
using Styrofoam kernels, overfill the box and compress when closing the
lid. You need three inches of cushioning on all sides of the instrument.
3. Seal the carton with shipping tape or industrial staples.
Connecting Power
The waveform monitor operates from a single-phase power source with the
neutral conductor at or near earth ground. The line conductor is fused for
over-current protection. A protective ground connection through the grounding
conductor in the power cord is essential for safe operation.
WARNING. When power is supplied, line voltage will be present in the waveform
monitor, even if the POWER switch is set to STANDBY
.
The waveform monitor operates from an AC line frequency of 50 or 60 Hz, over
the range of 90–250 Volts, without the need for configuration, except the power
cord. Refer to page 1–2 for the power cord options. The typical power draw is
75 W. Refer to Appendix A: Specifications for additional information on power
and environmental requirements.
AC Power Requirements