Filter
Top Products
41
E
L
E
C
T
R
O
N
I
C
S
ELECTRONICS PROCEDURE 10
DISCONNECTING/CONNECTING
THE MKIV JOYSTICK (FIGURE 2)
Disconnecting
1. Loosen the thumb screws on the connector
for the joystick.
2. Disconnect the joystick connector from the
controller connecter.
Connecting
1. Align the joystick connector with the control-
ler connecter.
2. Secure the joystick connector to the control-
ler connector using the thumb screws on the
controller connector.
WARNING
The excess joystick cable MUST be coiled,
tie wrapped and positioned on TOP of the
shroud - otherwise injury or damage may
result.
3. Coil any slack in the joystick cable and tie wrap
it together (DETAIL "A").
4. Position the coiled joystick cable on TOP of
the shroud (DETAIL "A")
FIGURE 2 - DISCONNECTING/CONNECTING
THE MKIV JOYSTICK
REPOSITIONING THE MKIV
JOYSTICK
WARNING
This procedure MUST be performed by a
qualified technician.
NOTE: The MKIV joystick is factory installed on the
side specified by the end user when ordering the wheel-
chair. To reposition the MKIV joystick onto the opposite
side of the wheelchair, contact a qualified technician.
Joystick
Thumb
Screws
Joystick
Connector
Controller
Connector
Shroud
Coiled
Joystick
Cable
Tie Wrap
DETAIL A