Filter
Top Products
16
This Procedure Includes the Following:
Armrest Angle Adjustment
Armrest Width Adjustment
Armrest Depth Adjustment
Armrest Height Adjustment
ARMREST ANGLE ADJUSTMENT
(FIGURE 1)
1. Lift the armrest up.
2. Loosen adjustment locknut.
3. Adjust mounting screw up or down to the
desired arm angle position.
4. Retighten adjustment locknut.
5. To determine the same angle for the opposite
armrest, count the exposed threads on the ad-
justment knob.
6. Repeat STEPS 1-4 for opposite armrest.
WARNING
After ANY adjustments, repair or service and
BEFORE use, make sure that all attaching
hardware is tightened securely - otherwise
injury or damage may result.
For the following procedures, make sure the
ON/OFF switch on the joystick is in the OFF
position.
FIGURE 2 - ARMREST WIDTH ADJUSTMENT
A
R
M
S
ARMSPROCEDURE 4
FIGURE 1 - ARMREST ANGLE ADJUSTMENT
Adjustment
Knob
Inside Of
Armrest
Back Of
Seat
Frame
ARMREST WIDTH ADJUSTMENT
(FIGURE 2)
1. Loosen the adjustment knob located on the
back of the seat frame.
2. Adjust the armrest in or out to the desired po-
sition.
NOTE: The armrest can be adjusted to a maximum
distance of 4.5 inches between the inside of the arm-
rest and the mounting shaft the armrest is inserted
into. If the armrest is adjusted beyond the maximum
4.5 inches, it will fall out.
3. Retighten the adjustment knob securely.
NOTE: Perform STEPS 4-5 to adjust BOTH arm-
rests to the same width.
4. Measure distance between the inside of arm-
rest and the mounting shaft the armrest in in-
serted into.
5. Repeat STEPS 1-4 for opposite armrest setting
armrest at distance determined in STEP 4.
Measure This
Distance
Adjustment
Locknut
Mounting
Screw
Armrest
Measure This
Distance
Shaft