Filter
Top Products
37
B
A
T
T
E
R
I
E
S
PROCEDURE 9
FIGURE 5 - CHARGING USING THE ON-BOARD
BATTERY CHARGER
AC Power Cord
(To 110-Volt Wall Outlet)
FRONT OF
WHEELCHAIR
Charging Using An Independent Charger
Plugged Into The Joystick (FIGURE 6)
NOTE: The charger port located on the FRONT
of the joystick requires the use of an independent
charger. The independent charger is NOT sup-
plied with the wheelchair
WARNING
READ and CAREFULLY follow the individual
instructions for each charger (supplied or
purchased). If charging instructions are not
supplied, consult a qualified technician for
proper procedures.
CAUTION
DO NOT use an independent charger
rated for over 6 amps. Otherwise, damage
may occur.
Required Items:
MODEL Battery Charger * Power Cord
Pronto™ M6 On-Board Supplied
* NOTE: AC power cord (3-prong plug, 15 am-
pere current rating; industrial type)
1. Grasp the charger port cover and remove it
from the charger port.
2. Plug AC power cord into the charger port lo-
cated in the FRONT of the wheelchair.
3. Plug AC power cord into 110-volt wall outlet.
4. Refer to
BATTERY CHARGER OPERATION
in this procedure of the manual.
5. When charging is complete, grasp the charger
port cover and position it in the charger port.
Charger
Port
Front View of Joystick
Independent
Charger Port
(Charger NOT
Supplied)
FIGURE 6 - CHARGING USING AN
INDEPENDENT CHARGER PLUGGED INTO THE
JOYSTICK
BATTERIES
NOTE: Seat NOT shown for clarity.
Required Items:
MODEL Battery Charger * Power Cord
Pronto™ M6 Not Supplied Not Supplied
* NOTE: AC power cord (3-prong plug, 15 am-
pere current rating; industrial type)
1. Attach the battery charger connector to the
charger port on the FRONT of the joystick.
2. Plug the charger’s AC power cord, or extension,
into the grounded 110-volt wall outlet.
3. Wait until charging is complete.
Charging Using The On-Board Battery
Charger (FIGURE 5)
WARNING
NEVER leave the charger unattended when
the circuit breaker (charger) is tripping ON
and OFF.
Charging LED
Indicator Light
Charger
Port Cover