Filter
Top Products
SECTION 9—HEADREST
Part No 1122170 61 Formula™ Powered Seating
Adjusting Headrest Height
1. Loosen the set screw on the headrest stop.
2. Loosen, but DO NOT remove, the thumb screw that secures the headrest to the
headrest mounting bracket.
3. Position the headrest to the desired height.
4. Tighten the thumb screw that secures the headrest to the headrest mounting bracket.
5. Tighten the set screw on the headrest stop.
6. If necessary, adjust the depth or direction of the headrest. Refer to Adjusting Headrest
Depth/Direction on page 61.
Adjusting Headrest Depth/Direction
1. Loosen, but DO NOT remove, the three socket screws that secure the offset fixture to
the slide tube.
2. If necessary, reposition the headrest to the desired depth by sliding the headrest
towards the front of the wheelchair or towards the rear of the wheelchair.
3. If necessary, reposition the headrest to the desired position (headrest will move in any
direction).
4. While holding the headrest in the desired position, securely tighten the three socket
screws.
5. If necessary, adjust the height of the headrest. Refer to Adjusting Headrest Height on
page 61.
Replacing Headrest
NOTE: For this procedure, refer to FIGURE 9.2.
1. Remove the three socket screws that secure the headrest to the headrest mounting
bracket.
2. Position the new headrest on the headrest mounting bracket and secure with the
existing three socket screws.
3. If necessary, adjust the height, depth or direction of the headrest. Refer to Adjusting
Headrest Height or Adjusting Headrest Depth/Direction on page 61.
FIGURE 9.2 Replacing Headrest
Headrest Mounting Bracket
Socket
Screw
Headrest
NOTE: One style of
headrest shown for
clarity. Both styles of
headrest attach the same
way.