Filter
Top Products
SECTION 6—FRONT RIGGINGS
Part No 1122170 37 Formula™ Powered Seating
70° and PW93
NOTE: For this procedure, refer to FIGURE 6.4.
1. Remove any accessory from the footrest(s).
2. Remove the footrest from the wheelchair. Refer to Installing/Removing Footrests on
page 35.
NOTE: Lay the footrest on a flat surface to simplify this procedure.
3. Remove the mounting screw, washers and locknut that secure the lower footrest
assembly to the upper footrest support (FIGURE 6.4).
4. Reposition the lower footrest to the desired height.
5. Reinstall the mounting screw, washers
and locknut that secure the lower
footrest to the footrest support and
tighten securely.
6. Repeat STEPS 1-5 for the opposite
wheelchair footrest, if necessary.
7. Reinstall the footrest(s) onto the
wheelchair. Refer to Installing/
Removing Footrests on page 35.
8. Reinstall any accessory onto the
footrest(s).
FIGURE 6.4 Footrest Height Adjustment -
70° and PW93
70° Taper
NOTE: For this procedure, refer to
FIGURE 6.5.
1. Remove any accessory from the
footrest(s).
2. Remove the footrest from the
wheelchair. Refer to Installing/
Removing Footrests on page 35.
NOTE: Lay the assembly on a flat surface to
improve access to the hardware.
NOTE: Note the position of the spacers before
disassembly.
FIGURE 6.5 Footrest Height Adjustment -
70° Taper
3. Remove the mounting screw and coved spacer that secures the lower footrest
assembly.
4. Position the footrest assembly to the desired height.
5. Secure lower footrest assembly with existing mounting screw and coved spacer.
Securely tighten.
Footrest Support
Coved
Washer
Hex Bolt
Lower
Footrest
Coved
Washer
Locknut
Coved Spacer
Mounting Screw
Heel Loop
Footrest