Filter
Top Products
SECTION 9—HEADREST
Formula™ Powered Seating 60 Part No 1122170
SECTION 9—HEADREST
ƽ WARNING
After ANY adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
CAUTION
If using a ventilator, verify headrest support does not interfere at ALL angles. Oth-
erwise, injury or damage may occur.
Removing/Installing/Adjusting Headrest
NOTE: For this procedure, refer to FIGURE 9.1.
Removing
1. Loosen, but DO NOT remove, the
thumb screw that secures the headrest
to the headrest mounting bracket.
2. Remove the headrest from the headrest
mounting bracket.
Installing
1. Make sure thumb screw is loose.
2. Install the headrest until the headrest
stop sits on the headrest mounting
bracket.
3. If necessary, adjust the height, depth or
direction of the headrest. Refer to
Adjusting Headrest Height on page 61
or Adjusting Headrest Depth/Direction
on page 61.
FIGURE 9.1 Removing/Installing/Adjusting
Headrest
Depth
Adjustment
Offset Fixture
Slide
Tube
Socket
Screws
Height
Adjustment
Thumb
Screw
Headrest
Mounting
Bracket
Headrest Stop
Set Screw