Filter
Top Products
SECTION 6—FRONT RIGGINGS
Formula™ Powered Seating 50 Part No 1122170
Calf Pad Adjustment for Power Center Mount Footrests
NOTE: For this procedure, refer to FIGURE 6.21 on page 50.
NOTE: Ensure footrest height has been adjusted before performing this procedure. Refer to
Adjusting the Height of the Center Mount Footrest on page 47.
Depth Adjustment
1. Remove the two depth adjustment screws securing the calf pad mounting bracket to
the carriage assembly.
2. Move the calf pad mounting bracket to the desired position.
3. Install the two depth adjustment screws to secure the calf pad mounting bracket to the
carriage assembly.
4. Check operation of the calf pads to ensure there is no interference with the seat pan or
the carriage assembly. If there is interference, readjust calf pad.
5. Repeat STEPS 1 to 4 for the opposite side, if desired.
FIGURE 6.21 Calf Pad Adjustment for Power Center Mount Footrests
Height/
Width
Adjustment
Screws
Carriage
Assembly
Depth Adjustment
Screws
Calf Pad
Calf Pad
Mounting Bracket