Invacare Powered Seating Mobility Aid User Manual


 
SECTION 5—WHEELCHAIR OPERATION
Part No 1122170 29 Formula™ Powered Seating
2. Rotate the knob counterclockwise (backward) to decrease the speed of the wheelchair
to the programmed max speed.
Joystick
The joystick has proportional drive control, meaning that the further the joystick is
pushed from the upright (neutral) position, the faster the wheelchair or seat moves. Your
top speed, however, is limited by the programmed settings.
To slow the wheelchair to a stop, simply release the joystick. The wheelchair has
automatic speed and direction compensation to minimize corrections.
Charger/Programming Input
The charger/programming input is located at the front of the joystick housing. This
provides easy access for charging the wheelchair batteries. This port also serves as the
Remote Programmer Communication connection. Driving is prevented while the system
is charging.
LCD Display Screens
The LCD Display is located in front of the joystick and provides information on the status
of the wheelchair through a backlit display. The LCD display is readable in both bright
sunlight and complete darkness.
Splash Screen
NOTE: For this procedure, refer to
FIGURE 5.4.
This screen is displayed at startup of the
joystick for about 2 seconds. This screen
displays the software version and date
information.
After this screen, the joystick displays the
Main Screen.
FIGURE 5.4 LCD Display Screens - Splash
Screen
Main Screen
NOTE: For this information, refer to FIGURE 5.5 on page 31.
During normal operation, the active drive is displayed in the upper half of the LCD
display. Battery charge level is shown in the Battery Gauge Display (BGD) located on the
right side of the LCD display. At full charge, solid blocks fill in all ten segments between
E (Empty) and F (Full). As the battery becomes discharged, the top most segments will
progressively disappear until no segments appear between E and F. At this level, the user
should charge the batteries as soon as possible.
The lower half of the LCD display is the Information Center. The Information Center
displays current data on the wheelchair.