Filter
Top Products
SECTION 6—FRONT RIGGINGS
Part No 1122170 47 Formula™ Powered Seating
Adjusting the Height of the Center Mount Footrest
ƽ WARNING
While the wheelchair is moving, minimum ground clearance for the front rigging is
three inches. If the wheelchair is not moving, the front rigging MUST maintain a
minimum of one inch ground clearance - otherwise personal injury and damage may
result.
NOTE: For this procedure, refer to FIGURE 6.16.
1. Remove the two mounting screws that secure the footrest extension tube to the
extension tube housing.
2. Adjust the footrest extension tube to the desired height and align the corresponding
holes to the mounting holes on the extension tube housing.
3. Reinstall the two mounting screws to secure the footrest extension tube to the
extension tube housing. Securely tighten.
4. Repeat STEPS 1-3 for the other extension tube.
FIGURE 6.16 Adjusting the Height of the Center Mount Footrest
Release Lever
Seat Frame
Extension
Housing
Extension Tube
Height Adjustment
Holes
Mounting Screws
Extension Tube Mounting Holes