Support User Manuals

Invacare Force Mobility Aid User Manual

Open as PDF

of 76

SECTION 9—OPTIONS

Recumbent Handcycle Series 64 Part No 1114850

Installing Hand Crank Handles

NOTE:Forthisprocedure,refertoFIGURE 9.9.

Horizontal Handles/Delrin

Handles

1. Securehandletohandcrankwiththe

screw(Detail“A”).

2. Removethescrewtoremovehandle

fromhandcrank.

Vertical Handles

1. Positionhandleontocrank(Detail“B”).

2. Tightensetscrewtosecurehandleto

crank.

3. ReverseSTEPS1‐2toremovehandle.

Tri-pin Quad Handles

1. Remove/installtri‐pinquadhandles.

RefertoVerticalHandlesonpage 64

2. Loosensocketscrewstoadjusthandle

position(Detail“C”).

3. Tightensocketscrewstosecure

handlesindesiredposition.

V or S Crank Handles

Replacement/installationofVorScrank

handlesshouldbedonebyaqualified

technician.

FIGURE 9.9 Installing Hand Crank Handles

Installing V/S Crankarm Handles

For Models Made Before 7/12/07

ƽ WARNING

Failure to install handle assembly properly could result in injury.

It is recommended to inspect this assembly prior to and after each use.

NOTE:Forthisprocedure,refertoFIGURE 9.10onpage65.

1. Securethehandletothecrankarmhousingusingthebolt,spacer,andtwobearings.

Horizontal Handle

DETAIL “A” - HORIZONTAL

HANDLES/DELRIN HANDLES

Hand Crank

Screw

Vertical Handle

DETAIL “B” - VERTICAL HANDLES

Hand Crank

Set Screw

Tri-Pin

Quad

Handle

DETAIL “C” - TRI-PIN HANDLES

Socket

Screw

previous next