Support User Manuals

Invacare Force Mobility Aid User Manual

Open as PDF

of 76

SECTION 8—SERVICE PROCEDURES

Recumbent Handcycle Series 50 Part No 1114850

FIGURE 8.2 Replacing the Crank Arms - XLT Gold, XLT PRO and Top End Force

Installing/Removing/Adjusting the Road Crown

Compensator

NOTE:Forthisprocedure,refertoFIGURE 8.3onpage51.

NOTE:Theroadcrowncompensatorisdesignedtostabilizethehandcycleduringtransfersand

whileridingandisnotintendedtokeepthehandcyclestraightwhenpedalingbuttokeepthe

handcyclefromleaningexcessivelytoonesideoranother.

Installing Road Crown Compensator

1. Positiontheboltthroughtheframeendoftheroadcrowncompensator.

2. Positionthespaceronthebolt.

3. Installtheboltwithspacerandroadcrowncompensatorintothemountingholeon

theframe.

4. Rotatetheforktoensurethefrontwheelispointingdirectlyforward.

5. Positiontheforkendoftheroadcrowncompensatorontheforkbolt.

NOTE:Ifnecessary,lengthenorshortentheroadcrowncompensatortopositiontheforkendonto

theforkbolt.RefertoAdjustingRoadCrownCompensator

onpage 51.

6. Securetheroadcrowncompensatortotheforkboltwiththelocknut.Tightensecurely.

Right Crank Arm (Tabs)

Spindle, Socket

Screw and Cap

Chain

Ring Disk

Socket Screws

Crank Arm Clamp

Left Crank Arm

Mounting Bolts

and Locknuts

Crank Arm Clamp and

Socket Screws

Spindle, Socket

Screw and Cap

previous next