Support User Manuals

Invacare Force Mobility Aid User Manual

Open as PDF

of 76

SECTION 6—RIDING POSITION

Part No 1114850 35 Recumbent Handcycle Series

Adjusting Top End XLT Gold Hand Crank

NOTE:Forthisprocedure,refertoFIGURE 6.5.

Adjusting Hand Crank Height

1. Loosen,butDONOTremovethehexnutsecuringthehandcranktotheforkstem.

2. Loosen,butDONOTremovethetwosetscrewsfortheupperclamp.

3. Movethehandcrankassemblyupordownintheforkneckuntilyouarecomfortable

withthepositionforoperationalpurposes.

NOTE:Thehandcrankshouldbepositionedsothatwhenthehandistowardthefrontofthe

handcycle,thearmisslightlybent.ThearmshouldNEVERbefullyextended(locked)atanypoint

whilecranking.

4. Tightenthehexnuttosecurethehandcrankinthedesiredposition.

5. Tightenthetwosetscrewsontheupperclamp.

6. Tightenthechainifnecessary.RefertoAdjustingSevenSpeedHubChainonpage 55

orAdjustingTwenty‐SevenSpeedCassetteChainonpage 56.

FIGURE 6.5 Adjusting Top End XLT Gold Hand Crank

Hex

Nut

Fork Neck

Upper Clamp

and Set

Screws

Hand Crank

(Gear and Chain Not Shown)

previous next