Support User Manuals

Invacare Force Mobility Aid User Manual

Open as PDF

of 76

SECTION 6—RIDING POSITION

Part No 1114850 39 Recumbent Handcycle Series

Adjusting Back Angle - All Models Except XLT Gold and

Top End Force

NOTE:Forthisprocedure,refertoFIGURE 6.9.

1. Ifinstalledactivateparkingbrake.

2. Loosen,butDONOTremovethefourrearsocketscrewsthatsecuretheseatframeto

thehandcycleframe.

NOTE:Therearetwosocketscrewsontherightandleftsideofthehandcycle.

3. Loosen,butDONOTremovethehexboltsandlocknutsthatsecurethetwoseatangle

adjustmentclampstotherearseatsupports.

NOTE:Thereisoneclampontherightandleftsideofthehandcycle.

4. Performoneofthefollowing:

• IncreasingBackAngle‐Whileliftinguponthebacksupporttubes,pulltheseat

upwardtothedesiredposition.

• DecreasingBackAngle‐Whilepushingdownonthebacksupporttubes,pushthe

seatdowntothedesiredposition.

5. Tightenthefoursocketscrewsthatsecuretheseatframetothehandcycleframe

securely.

6. Tightenthehexboltsandlocknutsthatsecurethetwoseatangleadjustmentclamps

totherearseatsupportssecurely.

FIGURE 6.9 Adjusting Back Angle - All Models Except XLT Gold and Top End Force

Seat Angle Adjustment Clamps

Back Support Tube

Rear Socket Screws

Handcycle Frame

previous next