Support User Manuals

Invacare Force Mobility Aid User Manual

Open as PDF

of 76

SECTION 8—SERVICE PROCEDURES

Part No 1114850 47 Recumbent Handcycle Series

19. Slidethebottombearingontothenewfork.RefertoFIGURE 8.1forcorrect

orientation.

20. Slidethenewforkintotheframe.

21. Positiontheo‐ringandbearingonthenewfork.RefertoFIGURE 8.1forcorrect

orientation.

22. Installthetwonutsontothenewforkandtightensecurely.RefertoFIGURE 8.1for

correctorientation.

23. Positionthefootrestclampsonthenewframe.

24. InstallthefootrestsontothenewforktothepositionnotedinSTEP17andsecurewith

thetwohexboltsandlocknuts.

25. Positionthechainaroundthehubofthefrontwheel.

26. Installthefrontwheelontothenewfork.

NOTE:Makesurethewasherandthenon‐turnwasherareontheoutsideofthenewfork.

27. Lineuptheprojectingendsofthenon‐turnwasherwiththeslotinthenewfork.

28. RepeatSTEPS27‐28untiltheprojectingendsofthenon‐turnwasherlineupwiththe

slotinthenewfork.

29. Torquethetwocapnuts260‐390in‐lbs.

30. Installthebrakearmclampontothenewfork.

31. Securethebrakearmtothebrakearmclampwiththehexboltandlocknut.Torqueto

22‐26inch‐pounds.

32. Reinstalltheshiftingleverontotheseatframeandsecurewiththesocketscrew.

33. Installtheroadcrowncompensatororsteeringdampenerontothenewfork.Referto

InstallingRoadCrownCompensatoronpage 50orInstallingSteeringDampeneron

page 52.

34. Installthebrakeassemblyontothenewfork.Refertothehardwarepositionnotedin

STEP8andtightensecurelywiththesocketnut.

35. Slidethecrankhandlesontothenewfork.

NOTE:Makesur ethesprocketonthecrankhandlesisinlinewiththesprocketonthefrontwheel.

36. Reinstallthechainontothecrankhandlesprocket.

37. MovethecrankhandletothepositiondeterminedinSTEP1andtighenthetwosocket

screwssecurely.

previous next