Support User Manuals

Invacare Force Mobility Aid User Manual

Open as PDF

of 76

SECTION 6—RIDING POSITION

Recumbent Handcycle Series 34 Part No 1114850

Adjusting Hand Crank

ƽ WARNING

DO NOT operate the handcycle if the hand crank obstructs your view. If the hand

crank obstructs your view, adjust the height before using the handcycle - otherwise

injury or damage may occur.

Adjusting Hand Crank Height - All Models Except Top End XLT Gold

NOTE:Forthisprocedure,refertoFIGURE 6.4.

1. Loosen,butDONOTremovethetwo

setscrewssecuringthehandcrankto

theforkstem.

2. Movethehandcrankassemblyupor

downontheforkstemuntilyouare

comfortablewiththepositionfor

operationalpurposes.

NOTE:Thehandcrankshouldbepositionedso

thatwhenthehandistowardthefrontofthe

handcycle,thearmisslightlybent.Thearm

shouldNEVERbefullyextended(locked)at

anypointwhilecranking.

FIGURE 6.4 Adjusting Hand Crank Height -

All Models Except Top End XLT Gold

3. Tightenthehexnuttosecurethehandcrankinthedesiredposition.

4. Tightenthechainifnecessary.RefertoAdjustingTwenty‐SevenSpeedCassetteChain

onpage 56.

Set Screws

Fork Stem

Hand Crank

previous next