Support User Manuals

Invacare Force Mobility Aid User Manual

Open as PDF

of 76

SECTION 7—WHEELS

Part No 1114850 45 Recumbent Handcycle Series

Adjusting Toe In/Toe Out

1. Loosen,butDONOTremovethesocketscrewsandclampsthatsecurecamberinserts

tothecamberbar(DetailʺAʺ).

2. Slowlyrotatethecamberinsertuntiltherearwheelsareapproximatelyinastraight

line.

3. Securelytightenthesocketscrewsandclampsthatsecurethecamberinsertstothe

camberbar.

4. Measurethedistancebetweenthecenterlinesattherearandfrontoftherearwheels

atapproximately12inchesfromtheground/floor.RefertoDeterminingToeIn/Toe

Outonpage 44.

5. RepeatSTEPS1‐4untilthetoein/toeoutmeasurementislessthan1/8‐inch(for

maximumrollability).

Replacing Camber Inserts

NOTE:Forthisprocedure,refertoFIGURE 7.4.

1. Loosen,butDONOTremovethesocketscrewsandclampsthatsecurethecamber

insertstothecamberbar.

2. Removetheexistingcamberinsertfromthecamberbar.

3. Installthenewcamberinsertintothecamberbar.

4. Adjustthetoein/toeoutofthehandcycle.RefertoDetermining/AdjustingToeIn/Toe

Outonpage 44.

FIGURE 7.4 - Replacing Camber Inserts

Clamp

Camber Bar

Socket Screw

Camber

Insert

Frame

previous next