Status and Error Codes
CM 4000 Installation and Operating ManualR−8
41 Receive failed for UDP port 0x%x errno=0x%x
There may be a problem with the LAN hardware or external LAN connections. This is typically seri-
ous.
42 Invalid UDP destination name ’%s’ on port 0x%x
There may be a problem with the LAN hardware or external LAN connections. This is typically seri-
ous.
43 Error setting non blocking for port 0x%x
There may be a problem with the LAN hardware or external LAN connections. This is typically seri-
ous.
44 Invalid logical multicast address 0x%04x
There may be a problem with the LAN hardware or external LAN connections. This is typically seri-
ous.
45 Could not create ’%s’ task
There may be a problem with the LAN hardware or external LAN connections. This is typically seri-
ous.
46 Could not create the virtual master array (step %d).
The virtual input master array (list of outputs that can be used as virtual inputs) was not created. The
system will not be able to perform virtual input switching. (Step indicates where the process failed)
47 The virtual input master table is corrupt (cause %d).
The virtual input master array is corrupt. The system will not be able to perform virtual input switch-
ing. (Cause indicates where the corruption occurred.)
48 Cannot find any levels configured for this board (%d).
There are no levels configured for this board. You must build a valid configuration and reboot.
49 Bad config request: %s (task %x)
An improper configuration request was made. This is a programming error and should be reported to
technical support.
4A Cannot load serial card for this board.
Unable to load files for the coldfire serial card. Either the boot loader or serial processor application
program failed to run on one or more serial processors. This indicates a failure of one of the serial
processors.
4B SerialTimeSync failed to set a serial processor time reference.
A synchronize time command is sent to each serial processor. If the processor fails to set its time this
event is logged. The processor may also fail to load protocols if the synchronize time command fails.
This indicates that the processor control channel is not responding.
4C One or more serial protocols did not start correctly.
One or more of the configured serial protocols failed to load on one or more of the connected serial
processors. This indicates a serial processor control channel failure or incorrect protocol module. A
probable cause is that the serial protocols tables define an invalid protocol for this board.
4D Serial processor watchdog expired on card %d.\nProcessor Restarted.
The indicated serial processor failed to reset the hardware watchdog timer indicating that a hang
condition existed on the processor. The processor was reset by hardware and its program will be re-
started.
