Software Control Panel Suite
7−2 CM 4000 Installation and Operating Manual
S Machine Control Devices table
These entries are described on the following pages. Guidelines for using the table editor are found on page 5−3.
For information about management of Configuration Sets, including compiling and activating sets, see page 5−8.
NETWORK DESCRIPTION TABLE
Network Description
RednBoard Name
PC1
PC
Address
1
Type
192.168.253.2
Figure 7−1.
Board Name
Create a name for the PC that will display the Software Control Panels.
For Jupiter naming rules, see page 5−7.
Type
Select board type “PC.”
Address
Enter the IP address of the PC (e.g., “192.168.253.2”).
To find out the IP address, go to Start > Programs > Jupiter Network Suite > JNS Configuration.
In some cases, there may be two network cards installed—one for Jupiter and another for a facility LAN.
If you are not sure which address is correct for the Jupiter card, try looking at Network Neighborhood >
Properties (right click for Properties), then Protocols > TCP/IP Protocol > Properties > Adapter; usually
the Jupiter card will be a 3Com. Click on 3Com to see the IP address of the card.
