3Com CM 4000 Manual

A SERVICE OF

next previous

Configurator

5−17CM 4000 Installation and Operating Manual

Figure 5−13.

CM 4000

Copy of

Application

(executable code)

Downloaded

Set

Executing

Application

Operating

set

Reboot Reboot

“CONFIGURATION

PENDING REBOOT”

is indicated when

these two sets do not

match

Figure 5−14.

CM 4000

Copy of

Application

(executable code)

Downloaded

Set

Executing

Application

Operating

set

Reboot Reboot

“CODE

PENDING

REBOOT” is

indicated when

these two sets

do not match

Note: Due to the size of the application, the operator may observe “Mismatch” in the Code column while the download

is in progress (this is illustrated on page 5−17). The operator should wait until the Code column indicates “Pending Re-

boot” before continuing.

3. Once the Configuration or Code is successfully downloaded, as indicated by “Pending Reboot,” the operator can, at a

convenient time, select the processors either individually or by clicking “Select All” and then initiate a reboot of the

processor by clicking “Reboot” (or “Clear PMEM”). The result is shown in Figure 5−15.