JNS CP I/O Set Editor
10−9CM 4000 Installation and Operating Manual
Figure 10−13.
The window contains a list of users and their password levels. Actual passwords are not displayed in this window. Each pass-
word is assigned a level 1 through 4. This level determines the entries in the table that the operator has authority to change.
Level 4 is the highest and can change any entry. Level 3 can change levels 1, 2, and 3. Level 2 can change levels 1 and 2, while
level 1 passwords can only change level 1 entries.
A level 4 user can add, delete, or change entries in the password table by selecting the entry and then the Add, Delete, or
Change buttons. Adding or changing entries will bring up the following window:
Figure 10−14.
This dialog contains a 20 character (maximum) name, an eight character (maximum) password, and a single digit level. Levels
are entered using a drop−down box.
Compare Sets
This option provides a comparison utility between two sets. The sets must be of the same type; i.e. both input sets or both
output sets. The Compare Sets window shown provides the user with a complete list of sets.
