A SERVICE OF

logo

Open as PDF
next previous
Hardware Installation
2−50 CM 4000 Installation and Operating Manual
Hardware Installation
Installation of this panel is shown on page 2−37.
If desired, the panel hardware can be tested, and window/button brightness adjusted, without being connected to the controller
board (such as a CM 4000). For more information, see Diagnostics Mode on page 6−112.
Software Configuration
The panel uses an eight−character CP Level Set of type “3800” (page 5−58).
MPK table entries will depend on the application (see page 5−107).
Sources are defined in a CP Input Set of type “cp3832” (page 5−62). Destinations are defined in a CP Output Set of type
“cp3832” (page 5−78).
Before the panel can be used, these sets must be compiled, and the appropriate configuration set made active using the Control
Center (page 5−13).
For CP 3832 operating instructions, see page 6−100.
For CP 3832L operating instructions, see page 6−117.