JNS Remapping
16−5CM 4000 Installation and Operating Manual
System Definition
From this menu you can select range sizes, idle inputs, and idle outputs on a level basis. The following dialog box will be
presented:
Figure 16−7.
The Switcher Name, Switcher Level, #In and #Out fields are read from the active set’s Switcher Description table and cannot
be modified. The range is selected from a drop−down list. Range numbers from one to the minimum of 64 and #In/Out are
valid.
Setting Idle Inputs/Outputs
To define the input groups available for remapping, or the idle inputs, first select the level; the grayed Idle Inputs/Outputs
button will be enabled. Press either the Idle Inputs or Idle Outputs button.
Figure 16−8.
The heading line shows the switcher and level names. Next, define the group by specifying a physical input number and a
count. The system will perform error checking to make sure that each input is not part of another group. The system will not
check against the size boundaries for that level, as the user may desire to map one input at a time. When OK is selected, all
changes are written to a binary file for future use.
