Control Panel Operation
MC 3000
6−132 CM 4000 Installation and Operating Manual
MC 3000 CONTROL FUNCTIONS
Toggles the machine in and out of scanner ready mode.
Stops machine regardless of mode.
Playback mode. May or may not override current mode, depending on machine.
Slow motion playback. Speed is indicated in the display window.
May or may not override current mode, depending on machine. When first
pressed, speed will be 1/5 or +0.2 play speed. Typical speed range, using variable
speed knob, is −1 to +3 times play speed.
Captures current time code.
The actual value will depend on the machine and interface used. For more infor-
mation, see Appendix E.
Go to time code point captured with Set Mark command, minus Preroll value set
on the Machine Control Devices table, and stop. For more information, see Pre-
roll on page 5−140.
For more information, see Appendix E.
End record mode (same as ESbus Exit command). Normally used to terminate
an Insert edit, in which case machine drops out of record mode but keeps on play-
ing.
When machine is stopped, pressing RECORD OUT also serves to place machine
in Tape Monitor mode.
SET
MARK
VAR
PLAY
STOP
RDY
SRCH
MARK
REC
OUT
>
>
