Getting Started 10
Important!:
Verify that the handset battery is installed prior to connection. If the
battery is not properly installed and the wall charger is connected,
the handset may power off and on continuously, preventing proper
operation.
2. Plug the flat end of the Travel Adapter into the Power/
Accessory Interface connector and the other end into a
standard AC wall outlet.
3. When charging is finished, remove the flat end from the
interface connector jack on the phone.
Warning!:
If your handset has a touch screen display, please note that a touch
screen responds best to a light touch from the pad of your finger or
a non-metallic stylus. Using excessive force or a metallic object
when pressing on the touch screen may damage the tempered
glass surface and void the warranty. For more information, refer to
“Standard Limited Warranty” on page 133.
Note:
Failure to unplug the wall charger before you remove the battery, can
cause damage to the phone.
Low Battery Indicator
When the battery is weak and only a few minutes of talk time
remain, the battery icon ( ) blinks and the device sounds a
warning tone at regular intervals. In this condition, your phone
conserves its remaining battery power, not by turning off the
backlight, but by entering the dimming mode. For a quick check of
your battery level, glance at the battery charge indicator located in
the upper-right corner of your device’s display.
When the battery level becomes too low, the phone automatically
turns off.
a885.book Page 10 Tuesday, November 3, 2009 1:39 PM
