A SERVICE OF

logo

Printer
BPX Switch Peripherals C-3
The High Speed Serial Interface DIP Switch consists of two DIP switches, SW1 and SW2, located
on a serial-board that is attached to the printer's main board. Set switches 1 and 2 as indicated in
Table C-4 and Table C-5.
Table C-4 Switch 1 SettingsOkidata 184 Printer
Table C-5 Switch 2 SettingsOkidata 184 Printer
Switch 1 Setting Description
1 On Odd parity.
2On No parity.
3 On 8 data bits.
4 On Ready/busy protocol.
5 On Test select circuit.
6OnPrint mode.
7 On Busy line selection.
8 On DTR pin 2 enabled.
Switch 2 Setting Description
1 Off Transmission
2 On Speed = 9600 baud.
3 On Speed = 9600 baud.
4On DSR active.
5 On Buffer = 32 bytes.
6 On Timing = 200 ms.
7 On Space after power on.
8 Don’t care Not used.