A SERVICE OF

logo

Open as PDF
next previous
11-10 Cisco BPX 8600 Series Reference
Replacing Parts
Figure 11-3 DC Power Entry Module with Conduit Box
Step 6
If a conduit box is used, remove it. Remove the ground screw above the middle terminal
block connector (see Figure 11-3).
Step 7 Remove the two standoffs on each side of the terminal block and pull the conduit box
straight back. Set it aside. Do not try to remove the terminal block.
Step 8 Loosen the two captive screws (at the bottom corners) holding the PEM. Loosen the two
connector jackscrews adjacent to the finger pull.
Step 9 Grasp the finger pull lip at the top of the PEM and pull the unit straight out.
Step 10 Replacement is the reverse of removal.
Conduit cover
screws
Conduit box
cover
CB1
O
N
O
F
F
USE COPPER
CONDUCTORS ONLY
CB1
O
N
O
F
F
USE COPPER
CONDUCTORS ONLY
+RTN –48V
90° terminal lug
(3 places)
H8005
Conduit connection
(customer supplied)
0
0