9-24 Cisco BPX 8600 Series Reference
Configuration Example
Sample Display:
Sample Display:
n4 TN SuperUser BPX 15 9.1 Apr. 4 1998 16:41 PST
Qbin Database 4.1 on BXM qbin 10
Qbin State: Enabled
Minimum Bandwith: 0
Qbin Discard threshold: 65536
Low CLP/EPD threshold: 95%
High CLP/EPD threshold: 100%
EFCI threshold: 40%
Last Command: cnfqbin 4.1 10 e 0 65536 95 100 40
Next Command:
Step 9 Configure the Qbin 10 for ports 4.2 and 4.3 by performing the procedures in the previous
step, but entering port 4.2 and 4.3 where applicable.
Step 10 5. Add a VSI controller to port 4.1, controlling partition 1
addshelf 4.1 vsi 1 1
Note The second “1” in the addshelf command is a controller ID. Controller IDs must be in the
range 1-32, and must be set identically on the TSC and in the addshelf command. A controller id of
1 is the default used by the TSC.
Sample Display:
n4 TN SuperUser BPX 15 9.1 Apr. 4 1998 16:42 PST
BPX Interface Shelf Information
Trunk Name Type Alarm
3.1 j6c AXIS MIN
5.3 j5c IPX/AF MIN
4.1 VSI VSI OK
Last Command: addshelf 4.1 vsi 1 1
Next Command:
