Tag Switching 9-49
dspnode
dspnode
Displays a summary of interface devices connected to a routing node, or when executed from an IPX
or IGX interface shelve shows the name of its hub node and trunk number.
Syntax:
dspnode
Related Commands
addshelf, delshelf, dsptrk
Attributes
Description
The command displays tag switch controller devices connected to a BPX node and interface shelves
connected to an IGX switch or BPX node. The command can be used to isolate the shelf or tag switch
controller where an alarm has originated.
The routing nodes in a network do not indicate the interface shelf or tag switch controller where an
alarm condition exists, so dspnode may be executed at a hub node to find out which interface device
originated the alarm.
When executed on an IPX or IGX interface shelve, dspnode shows the name of the hub node and
the trunk number. Note that to execute a command on an IPX or IGX interface shelf, you must either
use a control terminal directly attached to the IPX or IGX switch or telnet to the IPX/AF, as the vt
command is not applicable.
Privilege Jobs Log Node Lock
1-6 No No BPX switch, IGX switch Yes
