BXM T3/E3, 155, and 622 6-43
Resource Partitioning
Note The preceding example displays a screen with the Protocol parameter set to None. If Protocol
had been set to LMI or ILMI, the LMI parameters would also appear on the screen. The SVC
parameters that need to be configured will remain the same, however.
Step 5 Configure the desired SVC Channels, SVC VPI Min, SVC VPI Max, and SVC
Bandwidth as desired.
Step 6 Next configure the SVC Port Queue depth with the cnfportq <port num> command
shown in the following example:
Example: ASI cnfportq Command
spvc21 VT SuperUser BPX 15 9.1 Sep. 24 1997 07:50 GMT
Port: 2.1 [FAILED ]
Interface: MMF-2
Type: UNI
Speed: 353208 (cps)
SVC Queue Pool Size: 400
CBR Queue Depth(64-cell blks):16
CBR Queue CLP High Threshold: 80%
CBR Queue CLP Low Threshold: 60%
CBR Queue EFCI Threshold: 80%
VBR Queue Depth(64-cell blks):50 UBR/ABR Queue Depth(64-cells blks):28
VBR Queue CLP High Threshold: 80% UBR/ABR Queue CLP High Threshold: 80%
VBR Queue CLP Low Threshold: 60% UBR/ABR Queue CLP Low Threshold: 60%
VBR Queue EFCI Threshold: 80% UBR/ABR Queue EFCI Threshold: 80%
This Command: cnfportq 2.1
SVC Queue Pool Size [400]:
Virtual Terminal
Step 7 Configure the SVC Queue Pool Size with this menu. Other parameters are for PVCs.
Step 8 Repeat SVC resource partitioning for every ASI port that you want to support SVCs in
the BPX Switch.
