Filter
Top Products
67
◆
IMPORTANT
If you fail to completely insert the test strip,
the test may start; however, you may receive an
out-of-range result.
◆
IMPORTANT
You have up to 2 minutes to insert the test
strip after the linearity solution is applied. If
you insert the test strip after 2 minutes, you
may get an out-of-range result or an error
message. Discard the test strip and repeat the
test with a new test strip.
The test result appears in
approximately 30 seconds. The
time may vary depending on
the temperature and glucose
level.
◆
IMPORTANT
Do not remove the test strip
until the countdown is
complete.
■
NOTE
The bedside unit can display linearity results
up to 766 mg/dL.
BU.book Page 67 Monday, October 28, 2002 11:14 PM