Filter
Top Products
Data Management
48
If the workstation modem
phone number was not pre-
programmed, enter the
phone number, then press
Dial. If the phone number
appears on the screen, simply
press Dial.
A series of messages are
displayed on the screen
indicating the status of the
transfer. When the transfer
is complete, the bedside unit
beeps and a message appears.
Remove the bedside unit
from the connection module
and press Cont. to continue.
If the bedside unit is off when you remove it
from the connection module, you can check to
see that the transfer was successful by turning
on the bedside unit. If an error occurred during
transfer, the following message appears after
the Status screen:
Last Data Transfer mm/dd/yy hh:mm Failed.
1
Enter Phone #
2
3
4
5
6
7
8
9
0
Del
Menu
Wait
Dial
9236699
Clear
3
BU.book Page 48 Monday, October 28, 2002 11:14 PM