Filter
Top Products
SECTION 10—OPTIONS
9000 Topaz™Wheelchair 52 Part No. 1100869
2. With the footboard in the up position, pull the footboard support release lever and
position the right footboard assembly support in front of the wheelchair.
3. Install the hinge plates on the footboard support assembly onto the hinge pins on the
wheelchair frame.
4. Push the footboard support assembly towards the inside of the wheelchair until it
locks into place.
5. Repeat STEPS 2-4 for the left footboard support assembly.
6. With both footboard support assemblies locked into position, lower the footboard into
the down position and ensure the footboard clips securely hook over the left lower
footboard support tube, behind the end cap.
7. If necessary, adjust the height of the footboard support assembly. Refer to One Piece
Footboard Height Adjustment on page 53.
Removing
1. Lift the footboard into the up position.
2. Push the footboard support release lever inward.
3. Rotate the footboard support assembly outward.
4. Lift the footboard support assembly off of the hinge pins.
5. Repeat STEPS 2-4 for the other footboard support assembly.
FIGURE 10.10 Installing/Removing One-Piece Footboard
Footboard
Support
Release Lever
Wheelchair
Frame
Hinge
Pins
Hinge
Plates
Right Footboard
Support Assembly
Footboard
Left Lower
Footboard
Support Tube
End Cap
Footboard Clips
Left Footboard
Support Assembly
Footboard Support
Release Lever
Hinge
Pins
Hinge
Plates