Filter
Top Products
SECTION 10—OPTIONS
Part No. 1100869 51 9000 Topaz™Wheelchair
2. Align the remaining push bar support with the remaining back cane handle.
3. Insert the push bar support into the back cane handle. Securely tighten both lock
knobs.
Removing Push Bar
1. Completely unthread both lock knobs.
2. Firmly grasp both ends of the push bar and pull to remove the push bar from the back
cane handles.
FIGURE 10.9 Installing/Removing Push Bar
Installing/Removing One-Piece Footboard
NOTE: For this procedure, refer to FIGURE 10.10.
NOTE: Right and left sides of the wheelchair are determined from the occupant’s position.
NOTE: Only the right footboard support assembly is secured to the footboard.
NOTE: When in the upright position, the footboard will be vertical and resting against the inside
of the right footboard support assembly.
Installing
1. If necessary, remove the two (2) existing swingaway footrest assemblies from the
wheelchair by performing the following:
A. Push the footrest release lever inward.
B. Rotate swingaway footrest assembly outward.
C. Lift the swingaway footrest assembly off of the hinge pins.
D. Repeat STEPS A-C for the other footrest assembly.
Push Bar Support
Lock Knob
Push Bar
Lock Knob
Push Bar Support
Back Cane Handles