Filter
Top Products
SECTION 10—OPTIONS
Part No. 1100869 49 9000 Topaz™Wheelchair
FIGURE 10.7 Installing Telescoping I.V. Rod - Mounting Instructions
Repositioning Upper Mounting Bracket
NOTE: For this procedure, refer to FIGURE 10.8.
NOTE: This adjustment is required if the telescoping I.V. rod must be mounted on the right side of
the wheelchair.
1. With the telescoping I.V. rod in the lowest position, align the hole of the outer tube
with the phillips screw of the inner tube.
2. Remove phillips screw and set aside.
3. Remove the inner tube from the outer tube.
4. Firmly grasp the height adjustment assembly and pull to remove from the outer tube.
5. Slide the upper mounting bracket up off the outer tube.
6. Rotate the upper mounting bracket 180° and reinstall onto the outer tube.
7. Reverse STEPS 1-5 to reassemble the telescoping I.V. rod.
Washer
Locknuts
Upholstery
Mounting
Screw
Spacer
Step Tube
Lower
Mounting
Bracket
Wheelchair
Side Frame
Back Cane
Locknuts
Adjustment
Knob
Upper Mounting
Bracket
Telescoping I.V. Rod
Hex
Screws
Spacer
Lower
Mounting
Bracket
Hex
Screws
Long
Spacer
Short
Spacer
Bracket Plate
Bracket Plate
NOTE: Back upholstery not shown for clarity.
DETAIL “A”