Filter
Top Products
SECTION 10—OPTIONS
Part No. 1100869 45 9000 Topaz™Wheelchair
Installing Seat Positioning Strap
NOTE: For this procedure, refer to FIGURE 10.2.
1. Remove the two (2) existing back upholstery mounting screws and washer located
second up from the bottom of both back canes. Discard back upholstery screws and
washers.
NOTE: The seat positioning strap may be installed with the locking/releasing buckle on the right
or left side of the wheelchair back according to user preference.
2. Position the seat positioning strap around the outside of the back upholstery and back
canes.
3. Secure the seat positioning strap and back upholstery to the back canes with the two
(2) new back upholstery mounting screws and washers. Securely tighten.
FIGURE 10.2 Installing Seat Positioning Strap
Wheel Lock Extension Handle
NOTE: For this procedure, refer to FIGURE 10.3.
1. Remove the existing rubber tip from the wheel lock handle. Discard rubber tip.
2. Secure the wheel lock extension handle to the wheelchair frame by wrapping the
elastic cord around the wheelchair frame.
3. Pass the wheel lock extension handle through the loop end of the elastic cord.
4. Slide the wheel lock extension handle on to the wheel lock handle.
5. Repeat STEPS 1-3 for the remaining wheel lock.
Back
Upholstery
Mounting
Screws
Washer
Washer
Seat
Positioning
Strap
Locking/Releasing
Buckle
Back Canes