Filter
Top Products
SECTION 7—REAR WHEELS
9000 Topaz™Wheelchair 36 Part No. 1100869
SECTION 7—REAR WHEELS
ƽ WARNING
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Otherwise injury or damage may occur.
Removing/Installing Rear Wheels
ƽ WARNING
Changing the rear wheel size or changing the seat-to-floor height MUST be per-
formed only by a qualified technician.
NOTE: For this procedure, refer to FIGURE 7.1.
NOTE: If replacing the same size rear wheel, note the mounting position on the wheelchair frame
for proper reinstallation of the new rear wheel.
1. Place the wheelchair frame up on blocks so that the rear wheels are off the ground.
2. Remove the dust cap (if applicable), mounting screw and locknut that secure the rear
wheel and axle spacer to the wheelchair.
3. Repeat STEP 2 for the opposite rear wheel.
4. To reinstall the rear wheel onto the wheelchair, reverse STEP 2.
NOTE: Make sure axle spacer is between rear wheel and wheelchair frame.
FIGURE 7.1 Removing/Installing Rear Wheels
Locknut
Axle Mounting
Positions
Axle
Spacer
Wheelchair
Frame
Mounting
Screw
Rear Wheel